I am new to this whole cnc thing, so forgive me if this is s basic question.
I have created a design I want to cut out using DraftSight, and saved it as a DXF. However when I try to open the file in pycam it gives me an error "no supported elements found in dxf file". I am not sure what this means? Is there a problem with my file or is pycam not running correctly? I can open the test dxf file that came with the install.
Any advice would be helpful. Thank you
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I am new to this whole cnc thing, so forgive me if this is s basic question.
I have created a design I want to cut out using DraftSight, and saved it as a DXF. However when I try to open the file in pycam it gives me an error "no supported elements found in dxf file". I am not sure what this means? Is there a problem with my file or is pycam not running correctly? I can open the test dxf file that came with the install.
Any advice would be helpful. Thank you