Would it be possible to add a dialogue box to give the user the option of entering a start point (or quadrant/corner to start from ) for the first feed move? Depending on the setup and the part, it's sometimes good to start the tool in the upper left hand corner, or the lower left corner, etc...
My second question is this: what would it take to make the cutting paths run diagonal across the part?
If you could give me your thoughts on these questions, I might be able to do a little coding. I dabble in python a just bit.
Thanks,
Dan
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi Lode,
Would it be possible to add a dialogue box to give the user the option of entering a start point (or quadrant/corner to start from ) for the first feed move? Depending on the setup and the part, it's sometimes good to start the tool in the upper left hand corner, or the lower left corner, etc...
My second question is this: what would it take to make the cutting paths run diagonal across the part?
If you could give me your thoughts on these questions, I might be able to do a little coding. I dabble in python a just bit.
Thanks,
Dan
Those changes should not be too difficult... I'll see if and when I can look into this.