Hi!
Installed on Ubuntu 16.04, tried to make a gcode for pycam.stl. Unfortunately the toolpath seemed to cut out everything inside the bounds. I decided to test and confirmed - tool makes just a flat-bottomed box, nothing more. Other STLs produce the same.
Where should I start to investigate?
OK
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi!
Installed on Ubuntu 16.04, tried to make a gcode for pycam.stl. Unfortunately the toolpath seemed to cut out everything inside the bounds. I decided to test and confirmed - tool makes just a flat-bottomed box, nothing more. Other STLs produce the same.
Where should I start to investigate?
OK
PS. Found both the cause and the solution.
https://sourceforge.net/p/pycam/patches/15/
Maybe this should be fixed.
Hi,
I have converted the 'patch' into a GitHub issue:
https://github.com/SebKuzminsky/pycam/issues/43
nick.
Applied: 9239c178207c9c3dc11e467caa76a0418bde7085
Thank you!