Ok, so I hook up the drive to my computer, and it reads it fine, program loads no problem but then, it only reads 1 program. There's about 10 entries but they are all tied to one program on the Dish Hard Drive. I have to import them all just to get the program to import properly. what can I do? or what am I doing wrong?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Ok, so I hook up the drive to my computer, and it reads it fine, program loads no problem but then, it only reads 1 program. There's about 10 entries but they are all tied to one program on the Dish Hard Drive. I have to import them all just to get the program to import properly. what can I do? or what am I doing wrong?