Could you please add programming support for the ATmega2560 (and if possible the entire ATmega256* series).
There already seems to be some commented-out definitions / code for them, but with my very limited understanding of how PonyProg works I could not put these pieces of code to any use. I would appreciate it very much if you add support for these devices.
Thanks in advance
FYI: As it seems, the additions necessary are probably small since using the settings for an ATmega1280 does work to some extent with an ATmega2560. It displays several errors about the unrecognized device, but, errors ignored, the device's first half of the memory still gets written and the device actually does start up. As long as the memory used is small, it seems ok. Fuse bits work too (again ignoring errors and checking the numeric bit positions to be sure they match).
Log in to post a comment.