You must install http://prc-tools.sourceforge.net and
http://pilrc.sourceforge.net first.
> > -----Original Message-----
> > From: pil...@li...
> > [mailto:pil...@li...]On
Behalf Of Michael
> > Burke
> > Sent: Saturday, January 29, 2005 6:41 PM
> > To: pil...@li...
> > Subject: [pilot-db-list] Configure failure
> >
> > when i run ./configure i get the following error under linux:
> >
> > [mburke@localhost mburke]$ pilot-db/configure
> > checking whether make sets $(MAKE)... yes
> > checking for m68k-palmos-gcc... no
> > checking for m68k-palmos-coff-gcc... no
> > configure: WARNING: "Unable to find cross-compiler"
> > checking for m68k--gcc... no
> > configure: WARNING: "Unable to find cross-compiler"
> > configure: creating ./config.status
> > config.status: creating Makefile
> > config.status: creating rcp/Makefile
> > config.status: creating src/Makefile
> > mv: cannot move `./confstathL1hTR/out' to `src/Makefile':
> > Permission denied
> > config.status: creating def/
> > config.status: error: cannot find input file: def/.in
> >
> > can anyone tell me why src/makefile has the wrong
> > permissions and where it's located so I can fix it.
>
> Configure takes the results of its investigations and
creates a makefile
> based on what it discovered. It looks like it put its
results into
> `./confstathL1hTR/out', and is attempting to move that file
into the src
> directory as "Makefile".
>
> If it can't do so, likely reasons are
>
> 1) the src directory exists but the permissions on it won't
allow configure
> to write to it
>
> 2) the src directory *doesn't* exist, and configure either
has no provision
> to create it, or does not have permission to make the
directory under
> whatever directory it happens to be in
>
> We'd need to know more about your setup, like where you put
the DB stuff
> before you ran configure, to say much more.
>
> And judging from the warnings, you'll have other problems,
as you don't have
> a gcc cross-compiler installed that configure can locate.
If you are trying
> to build DB from source, the target processor is a Mororola
68K device.
> Stock gcc under Linux on a Intel box generates code for
Intel processors.
> You need a version of GCC set up to generate Motorola code
to get anywhere.
> ______
> Dennis
>
>
>
> -------------------------------------------------------
> This SF.Net email is sponsored by: IntelliVIEW --
Interactive Reporting
> Tool for open source databases. Create drag-&-drop reports.
Save time
> by over 75%! Publish reports on the web. Export to DOC, XLS,
RTF, etc.
> Download a FREE copy at http://www.intelliview.com/go/osdn_nl
> _______________________________________________
> Pilot-db-list mailing list
> Pil...@li...
> https://lists.sourceforge.net/lists/listinfo/pilot-db-list
> =0A=0AAcc=E9dez au courrier =E9lectronique de La Poste : www.laposte.ne=
t ; =0A3615 LAPOSTENET (0,34=80/mn) ; t=E9l : 08 92 68 13 50 (0,34=80/mn)=
=0A=0A
|
