Hey Everyone, I've got a completely newbie question.

I've used Win32::GUI a few times in the past to create simple interfaces, however I am now looking to create an interface that is a bit more complex.  What I would like to do is create a GUI that has a TreeView on the left hand side, and then on the right hand side have a Tab interface that supports 2-3 tabs.  I would always like the TreeView showing, which is simple enough, however i'm not sure how to add in the Tab interface to the right hand side so that the TreeView is not part of the tabs.  I hope i'm explaining this well enough.

Is this possible?  And if so, how would I go about doing this?

Also, I just upgraded to Win32::GUI v1.0 but was unable to find any samples directory.  Were these removed for a specific reason?  Just curious.

Thanks.

Len.

------------------------------------------------------------------------------
Electronic Privacy Notice. This e-mail, and any attachments, contains information that is, or may be, covered by electronic communications privacy laws, and is also confidential and proprietary in nature. If you are not the intended recipient, please be advised that you are legally prohibited from retaining, using, copying, distributing, or otherwise disclosing this information in any manner. Instead, please reply to the sender that you have received this communication in error, and then immediately delete it. Thank you in advance for your cooperation.
==============================================================================