[Perfparse-devel] RE: [Nagios-users] PerfParse Help?

[Cook, G. <GW...@ma...>]

Jon Lyons wrote:
> Ok, I finally got PerfParse installed and running, but
> only 6 hosts out of 200 are being displayed with
> graphs, I've updated to the latest plugings, and I can
> see all hosts in the view raw data section(see below),
> also perfparse is running very very slow. I've run the
> perfpase scripts many times, but only the 6 hosts are
> displayed, all my hosts have ping defined as a
> service..
>=20
[snip]

Perhaps someone else can explain this in greater detail, but from
looking at my setup, the raw data seems to show exactly what the plugins
would 'normally' show - host, service, status, check time, and output.
There does not appear to be any Performance Data listed here.
Perhaps if the perfdata was also included in the rawdata table we could
easily see which plugins support perfdata and which do not.
I think that the 6 hosts that you have graphs for are the only ones
being checked by plugins that support perfdata.
If in doubt about a plugin, run it from the command line and see if
there is a pipe and perfdata returned after the normal output.

I'm fairly sure that the check_ping does not yet have support for
perfdata enabled, but my plugins are from CVS about two weeks ago, so
that could have changed.=20

Garry W. Cook, CCNA
Network Infrastructure Manager
MACTEC, Inc. - http://www.mactec.com/
303.308.6228 (Office) - 720.220.1862 (Mobile)