Hi!
Welcome to the pcb2gcode mailing list!
You've forgotten the second dash before "zwork", it should be --zwork
not -zwork. Just a typo :-)
I'll try to come up with a better error message so the program doesn't
crash when this happens.
By the way, zsafe and zwork are read as "inches above the PCB surface",
you'll probably want something like --zsafe=0.1 --zwork=-0.008 (note the
minus in zwork!)
There's a file called "millproject" supplied with the source code, it
contains some conservative defaults for most parameters.
I know about the warning by configure, I don't think it'll be an issue
unless anybody tries cross-compiling the program or something.
Thanks for your message!
-- Patrick
On 10/02/2010 07:32 PM, Michał wrote:
> Hi, i have a problem with running pcb2gcode. When i type
> pcb2gcode --front psgroov_USB-PCB_Edges.gbr --zsafe 3 -zwork 2 i have error
>
> i have error
> terminate called after throwing an instance of 'std::runtime_error'
> what(): Invalid option.
>
> and during configuration
> checking for the toolset name used by Boost for g++... unknown
> configure: WARNING: could not figure out which toolset name to use for g++
>
> i use new ubuntu from linuxcnc
>
>
|
