[Pcb2gcode-devel] best way to add text to pcb

[John S. <jrs...@op...>]

Hi

I'm new to this list - just managed to mill a couple of s/s boards, with z-adjust -
in retrospect all the code worked amazingly well.  Kudos to all the developers.

It did raise a couple of questions on how I could do even better.

I added the board name and revision on the bottom of the artwork, in positive copper.

This looked interesting after being voroni-ised. Wasn't readable.
Is there a working way to get this part of the layout cut directly and legible?
Negative text would be nice in a solid area.


Also - is there a clever way of getting a big drill not in a tool table to mill using a small end 
mill -rather than drilled?

regards, john