Re: [Pcb2gcode-devel] problems with run

[M. <co...@op...>]

It still doesn't work, maybe need more options?
 
pcb...@li... napisał(a): 
 > There are a few parameters missing, try
 > 
 > pcb2gcode --back RGB_Lamp-Back.gbr  --zsafe=3 --zwork=-1 --offset=0.01 
 > --mill-feed=6.0 --mill-speed=20000 --zchange=0.8
 > 
 > then it should work.
 > I forgot to check those parameters for validity, I'll add that ASAP.
 > 
 > Thanks a lot for your feedback!
 > 
 > -- Patrick
 > 
 > 
 > On 10/03/2010 05:20 PM,  Michał  wrote:
 > > only 3 which are need to convert, maybe you will try to convert it with random value of options, maybe i write it to big.
 > >
 > > pcb2gcode --back RGB_Lamp-Back.gbr  --zsafe=3 --zwork=-1 --offset=0.01
 > >
 > > Now I only try to convert the file to lern how do it.
 > >
 > >
 > > "Patrick Birnzain"<pbi...@us...>  napisał(a):
 > >   >  Your gerber file works fine for me.
 > >   >
 > >   >  What command line options did you use?
 > >   >  I can see that I'll need to improve the parameter checking.
 > >   >
 > >   >  -- Patrick
 > >   >
 > >   >
 > >   >  On 10/03/2010 04:38 PM,  Michał  wrote:
 > >   >  >  Hi!
 > >   >  >
 > >   >  >  Thx for fast answer, now i have other error ;)
 > >   >  >
 > >   >  >  terminate called after throwing an instance of 'boost::exception_detail::clone_impl<boost::exception_detail::error_info_injector<boost::bad_any_cast>   >'
 > >   >  >     what():  boost::bad_any_cast: failed conversion using boost::any_cast
 > >   >  >
 > >   >  >  I sent you my gerber file, maybe it's bad, or i do something wrong. It,s file exported from KiCad.
 > >

-- 
Michał