#1 Incomplete printouts

I have installed Snake OS on my NS-K330. I believe this OS uses p910nd 0.93 as its printserver.

I have a Canon MP250 printer connected to it. It prints OK but it always leaves part of the last page out and remains with the paper stuck in it requiring a form feed. Then if you send another job to it in the meantime, it is most likely to start on that same last page rather than on a new page.

Can I do something?

Thanks

Neville

[Phil]

I had the same problem with a Canon iP 4200.
The solution was to turn the bidirectional connection off and to use the printer in unidirectional mode (on an OpenWRT-System, p910nd v 0.94)

edit: same with iP 4700