I have managed to install the Mesa, GLX, etc stuff and the actual Unreal tournament with the new patch witch should support my NVidia GeForce
card. I have the XFree86 3.3.6 installed.
When I try to run UT, I get this error message:
Couldn't set GL mode: No video modes supported. (??)
Signal: SIGSEGV [segmentation fault]
What might be wrong.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have a similar prob.
UT installs fine. I apply the 413a patch fine. Run it and the windows comes up then quits out.
My Setup : Mandrake 7, nVidia graphics Card(TNT2 ultra). SDL-1.1.3-1 & SDL-devel-1.1-3 installed (required for UT). Xdelta installed from RPM, unable to find source version on net.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
At first glance it looks like the mode you have asked to use in the UnrealTournament.ini file is not available under X - i.e. there are no valid modelines in XF86Config for the mode you want to use. Could be wrong though. A log would be very helpful - as would the output from strace if available.
<mutter> I must write the troubleshooting HOWTO one of these days...
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Please help, as I am a Linux newbie
I have managed to install the Mesa, GLX, etc stuff and the actual Unreal tournament with the new patch witch should support my NVidia GeForce
card. I have the XFree86 3.3.6 installed.
When I try to run UT, I get this error message:
Couldn't set GL mode: No video modes supported. (??)
Signal: SIGSEGV [segmentation fault]
What might be wrong.
Sorry for the double post, I had some connection problems.....
I have a similar prob.
UT installs fine. I apply the 413a patch fine. Run it and the windows comes up then quits out.
My Setup : Mandrake 7, nVidia graphics Card(TNT2 ultra). SDL-1.1.3-1 & SDL-devel-1.1-3 installed (required for UT). Xdelta installed from RPM, unable to find source version on net.
Could you post a log output?
At first glance it looks like the mode you have asked to use in the UnrealTournament.ini file is not available under X - i.e. there are no valid modelines in XF86Config for the mode you want to use. Could be wrong though. A log would be very helpful - as would the output from strace if available.
<mutter> I must write the troubleshooting HOWTO one of these days...