opensipstack-osbcdevel

[OpenSBC] proxy only and b2bua upper registration mode

[deveshbissa <bis...@ya...>]

Hi, 


I am using same configuration of opensbc and my x-lite siphone . 


What i observe that in both PROXY ONLY and B2BUA UPPER REG. modes giving same response. 


my configuration:- 


OpenSBC - trusted domain , privacy , b2bua routes , relay routes , internal dns mapping , local domain --- all blank (since i want to use upper registrar feature). 


upper registration routes-- --sip:*@privatedomain.com:*-- sip:ip-of-domain:port no. 





X-lite phone(3.0)-- user, id, password = dummyuser 


domain --- privatedomain.com:port no. 


enable - register with domain and get incomming calls 


proxy- ip-adrs-of-openSBC:portno.(according to listening interface of openSBC's general parameter setting). 





Please help me why i am getting same response from these two modes (i.e proxy only and b2bua upper reg.) ?


Thank you 


Devesh

Re: [OpenSBC] proxy only and b2bua upper registration mode

[Rajpal D. <raj...@as...>]

Make sure that you don't restart SBC immediately after change in mode. Many times it takes little longer (15-20 sec) to update the configuration in backend. I also struggled for a while as I was restarting SBC immediately after change in config. If you are sure that your mode change is effective, then there might be some other issue. Now my SBC in B2BUAUpReg mode is working fine with similar config (upper registration route only).


HTH,


/dangi