Re: [OpenSIPStack] opensbc media proxy?

[Joegen E. B. <joe...@gm...>]

OpenSBC will stay away from proxying media if the endpoints in the call 
are both using public addresses.   You can tell OpenSBC to always proxy 
media in all cases by setting "Always Proxy Media" in HTTP admin 
"General Parameters" section.

hth.

Joegen

Jeremy A wrote:
> Hello,
>
> In doing tests on 1.1.4 opensbc I notice that  the media stream is not
> being proxied.
>
> In my test setup I have a remote SIP registrar, and a local Linksys
> phone. Normally the phone registers with the remote proxy. I changed the
> phone setup to use an opensbc instance by setting the 'Outbound Proxy:'
> value on the phone.
>
> The following fields on the phone are set to 'no' or are blank.
>
> NAT Mapping Enable:
> SIP Proxy-Require:
>
> Handle VIA received:
> Handle VIA rport:   
> Insert VIA received:
> Insert VIA rport:   
> Substitute VIA Addr:
> Send Resp To Src Port:   
>
> The phone and the opensbc instance are on routable addresses
>
> The phone uses the opensbc in its SIP dialog as expected. My assumption
> was that the opensbc instance would automatically proxy the RTP audio as
> well as manage the SIP conversation.
>
> Is this assumption correct?
>
> Is there any special setting I need to make to the phone or openSBC to
> allow audio proxying?
>
> Thanks
>
> Jeremy
>
>
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2005.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> _______________________________________________
> opensipstack-devel mailing list
> ope...@li...
> https://lists.sourceforge.net/lists/listinfo/opensipstack-devel
>
>
>