Re: [OpenSIPStack] Upper Registration Routes

[voice <vo...@ne...>]

Hi



Can someone check my logic and setup?



I am using a Cisco ATA-186 in atasip 3.1.0 firmware with a public IPaddr
(69.x.x.x).

I am setting the OutBoundProxy on the ATAs' to my openSBC name/ipaddr ==
sbc.netxxxxxx.net with a public IP Address 69.x.x.50.

The ATA is registered in sipXecs 3.9.x also with a public IPaddr 69.x.x.40.



I am also using but not in this test several Cisco 26xx routers run nat/PAT.
These routers are in front several private networks.  The public side of the
NAT are connected to transceivers (69.x.x.x).  For testing both boxes are
hanging out on the Internet.  No firewalls, Nat nothing to get in the way
etc...



I would like to also have remote Internet (outside my network) ATA/IPPhones
register to the sipXecs.



On the openSBC I have set 'Upper Registration Routes' to point to the
sipxecs.  This is my string:

[sip:*@sbc.network.net*] sip:sipx.network.net:5060.

Using this approach will local and possibly the remote ATA be able to
register via the openSBC?



Using openSBC in this way do should i set SBC Mode something other then
'Full Mode'?



When using openSBC using 'Upper registration Routes'  is there a basic set
of setting i should be concerned with at the exclusion of other settings?





Are there any sipXecs folks on this list with similar issues' to mine?

I would be willing to open my test sipxecs and opensbc box's to further
development challenges in exchange for help setting up both boxes to
intergrate sipXecs and openSBC....



r