Re: [OpenSIPStack] [OpenSBC] Two (2) OSBC on net segment

[<sa...@ER...>]

Hi ehernaez

Three questions from when i left for vacation;  inbound  (PSTN -> Peering
OSBC -> Access OSBC -> SIPX

1. In the Peering OSBC servers General settings, which Mode will best set
Peering?  Since the Access must be set for B2Bua UpperRegister..

2.  Linking the Peering OSBC to the Access OSBC,  ideally what routes and
trust domains should be set on the Peering and Access OSBC?

3. Which of the two should have its SIP Trunk set.  Assuming that inbouund
from PSTN will never need trunking to the Access OSBC?

The SIPX wiil have set two SIP Trunks one for inbound from and one for
outbound to PSTN/ITSP

Warren Kreckler


----- Original Message ----- 
From: "ehernaez" <ope...@op...>
To: <ope...@li...>
Sent: Saturday, December 29, 2007 9:58 AM
Subject: Re: [OpenSIPStack] [OpenSBC] Two (2) OSBC on net segment


> Hi Warren,
>
> Here is the call flow that you can use to bridge the 2 OSBC instances:
> For an inbound call from PSTN:    ITSP -&gt; Peering OSBC -&gt;  Access
OSBC
> -&gt;  SIPXFor an outbound cal to the PSTN:  UA -&gt;  Access OSBC -&gt;
SIPX -&gt; Peering
> OSBC -&gt;  ITSP
> *inbound calls must be routed through the access OSBC in order to reach
> endpoints that are registered thru the access OSBC
> HTH
>
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2005.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> _______________________________________________
> opensipstack-devel mailing list
> ope...@li...
> https://lists.sourceforge.net/lists/listinfo/opensipstack-devel
>