Hi dear bwojtowi,I have got a Elonics E4000 and installed the openlte_v00-08-00.
But I don't know why we need to connect to the control port at port number 20000.
I could telnet to my ubuntu using the command telnet localhost.But the port is 23.
I have tried telnet localhost 20000,but system told me unable to connect to remote
host:Connection refused.So,could you tell me how to connect to the control port at
port number 20000.
I have tried many times,and it troubles me very much.I really need your help!Thanks
a lot!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
There is an command and control port setup on port 20000 when you launch
LTE_fdd_scan. This allows you to command and control the system without
the need to do everything on the command line.
You should be able to do the following:
1) Launch LTE_fdd_scan in one terminal
2) Connect to the command and control port in another terminal (telnet
localhost 20000 or nc localhost 20000)
3) Type help on the command and control port to see how to interface to
LTE_fdd_scan
Hi dear bwojtowi,I have got a Elonics E4000 and installed the
openlte_v00-08-00.
But I don't know why we need to connect to the control port at port number
20000.
I could telnet to my ubuntu using the command telnet localhost.But the
port is 23.
I have tried telnet localhost 20000,but system told me unable to connect
to remote
host:Connection refused.So,could you tell me how to connect to the control
port at
port number 20000.
I have tried many times,and it troubles me very much.I really need your
help!Thanks
a lot!
Hi dear bwojtowi,I have got a Elonics E4000 and installed the openlte_v00-08-00.
But I don't know why we need to connect to the control port at port number 20000.
I could telnet to my ubuntu using the command telnet localhost.But the port is 23.
I have tried telnet localhost 20000,but system told me unable to connect to remote
host:Connection refused.So,could you tell me how to connect to the control port at
port number 20000.
I have tried many times,and it troubles me very much.I really need your help!Thanks
a lot!
There is an command and control port setup on port 20000 when you launch
LTE_fdd_scan. This allows you to command and control the system without
the need to do everything on the command line.
You should be able to do the following:
1) Launch LTE_fdd_scan in one terminal
2) Connect to the command and control port in another terminal (telnet
localhost 20000 or nc localhost 20000)
3) Type help on the command and control port to see how to interface to
LTE_fdd_scan
Hope this helps,
Ben
On Fri, Mar 29, 2013 at 3:11 AM, leitao leitao520@users.sf.net wrote: