[Openlcb-svn-commits] SF.net SVN: openlcb:[3080] trunk/prototypes/C/CAN2USBuino_FT245/ CAN2USBuino_FT245.ino

[<jac...@us...>]

Revision: 3080
          http://openlcb.svn.sourceforge.net/openlcb/?rev=3080&view=rev
Author:   jacobsen
Date:     2013-03-23 19:41:01 +0000 (Sat, 23 Mar 2013)
Log Message:
-----------
improve comments

Modified Paths:
--------------
    trunk/prototypes/C/CAN2USBuino_FT245/CAN2USBuino_FT245.ino

Modified: trunk/prototypes/C/CAN2USBuino_FT245/CAN2USBuino_FT245.ino
===================================================================
--- trunk/prototypes/C/CAN2USBuino_FT245/CAN2USBuino_FT245.ino	2013-03-23 07:32:30 UTC (rev 3079)
+++ trunk/prototypes/C/CAN2USBuino_FT245/CAN2USBuino_FT245.ino	2013-03-23 19:41:01 UTC (rev 3080)
@@ -5,20 +5,7 @@
  * be used as an adapter between them.  The frames are sent in
  * what's commonly called the "GridConnect" protocol.
  *
- * Note that a serial speed of 333333 or above is needed to 
- * be certain of keeping up with a full CAN bus.  Not all
- * computers will connect at that speed.  In particular, 
- * Mac computers with standard FTDI drivers might only have
- * 230,400 or even 115,200 available as a standard rate.
- * By setting 8E2 or even better 8N2, 230400 here can be used with
- * a Mac at 230400 despite some internal baud issue in the
- * Arduino baud generation.
- *
- * For data directed from USB -> CAN, the sketch provides flow
- * control using the Xon/Xoff codes.
- * 
- * One of three baud rates can be selected by grounding (causing LOW input)
- * on one of two pins.
+ * This is for use with boards containing a FT245 USB adapter.
  */
 
 #include <arduino.h>
@@ -360,4 +347,4 @@
 uint8_t hex_to_byte(char *s)
 {
   return (char_to_byte(s) << 4) | char_to_byte(s + 1);
-}
+}

This was sent by the SourceForge.net collaborative development platform, the world's largest Open Source development site.