[OpenJade-devel] Problems running autoinit.sh for openjade 1.4

[Neil R. <ne...@oc...>]

This was an issue a while ago in the Debian package of OpenJade 1.4, and the
solution was simply to comment out the AC_SUBST(LIBOBJS) in configure.in.  It
was not even being used.  This was an older version, certainly not the latest
from cvs, but you could try doing the same and see if it works.  Or grep
through all the files in openjade for LIBOBJS to check if it is being used.

On May 27, Don Raikes (don...@or...) wrote:
 > Hello,
 > 
 > I am attempting to use cvsgnome to install gnome 2.2 onto a redhat advanced
 > server 2.1 system.
 > 
 > cvsgnome requires openjade to be installed.
 > When I checked out openjade from cvs, and ran autoinit.sh, I get the
 > following error:
 > 
 > autoinit.sh: Executing "autoconf"
 > configure.in:239: error: do not use LIBOBJS directly, use AC_LIBOBJ (see
 > section `AC_LIBOBJ vs LIBOBJS'
 >       If this token and others are legitimate, please use m4_pattern_allow.
 >       See the Autoconf documentation.
 > autoinit.sh: Execution of "autoconf" failed (exit status 1)
 > 
 > Any suggestions would be greatly appreciated.
 > 
 > Kernel is 2.4.9-e.12.
 > autoconf version 2.57
 > 
 > 
 > Cheers,
 > 
 > Don Raikes
 > home office (520) 579=-9481
 > HQ office (650) 506-9704
 > 
 > 
 > 
 > -------------------------------------------------------
 > This SF.net email is sponsored by: eBay
 > Get office equipment for less on eBay!
 > http://adfarm.mediaplex.com/ad/ck/711-11697-6916-5
 > _______________________________________________
 > OpenJade-devel mailing list
 > Ope...@li...
 > https://lists.sourceforge.net/lists/listinfo/openjade-devel

-- 
Neil Roeth