Re: [openadsl-users] modprobe hangs on solos_pci insert

[Jim C. <jam...@gm...>]

This is a generic cctv pci card that I am hoping to use with a zoneminder
install.  To be honest, I'd never heard of ATM before last week.  :-)

I ended up here as a result of using lspci to detect what the actual card
was capable of:

01:06.0 Multimedia controller: Xilinx Corporation Spartan 3 Designs (Xilinx
IP)
Subsystem: Xilinx Corporation Spartan 3 Designs (Xilinx IP)
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR+ FastB2B- DisINTx-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR- INTx-
Latency: 64 (250ns min, 63750ns max)
Interrupt: pin A routed to IRQ 10
Region 0: I/O ports at dc00 [size=16]
Region 1: Memory at fcf00000 (32-bit, non-prefetchable) [size=1M]
Kernel modules: solos_pci


This is way out of my area of expertise.  Any advice, including that I am
wasting my time in this endeavor would be appreciated.  Thank you for your
time.

-Jim



>Hi Jim,
>
>The solos_pci driver is for a specific Xilinx configuration, it is not
>generic.
>There are several registers that the driver expects to reside in the
>Xilinx, but they seem to be missing in your case.
>
>Is this your own Xilinx design?
>What is it that you are trying to build - an ATM card or something else?
>
>Regards,
>  - Guy.