I just installed NST34. When I configure snort it gets stuck on activating.I have tried destroying the instance and starting over but it does the same thing. I have tried using the local rules as well as rules with an oinkcode.
Any assistance is greatly appreciated.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I verified that the current snort setup works on our end. Can you please tell us a little about your system (i.e., CPU, memory, network adapter, etc...) and a screenshot of your snort page before starting up a snort instance.
Thank you,
Ron Henderson
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I just installed NST34. When I configure snort it gets stuck on activating.I have tried destroying the instance and starting over but it does the same thing. I have tried using the local rules as well as rules with an oinkcode.
Any assistance is greatly appreciated.
Lee:
Have you tried this:
Ok here is the solution for the snort stats action. We have published a public repository for NST 34.
For non-NST Pro users: On the command line type the following.
dnf clean all;
dnf upgrade nstwui nstwui-filesystem snort;
Let us know your results,
Ron Henderson
Hello Ron,
I ran the commands and update the snort version. After a reboot I tried again and I am getting the same results.
Thanks for your help.
Lee
Lee:
I verified that the current snort setup works on our end. Can you please tell us a little about your system (i.e., CPU, memory, network adapter, etc...) and a screenshot of your snort page before starting up a snort instance.
Thank you,
Ron Henderson