Hello everyone,
i try to connect NetToPlc to Tia v18 but it didn't work. I read in another forum that it work only up to tia v17, it's true?
if it's true, is a new realease work in progress?
Thank you so much
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I'm using Nettoplcsim successfully together with TIA V18. Only make sure you start your simulation setup in this order:
After PC start, before starting any Siemens application, start Nettoplcsim with admin rights and let it capture the TCP Port 102. Let Nettoplcsim in this state, with no configuration
Start Siemens Software, start Plcsim, load program into Plcsim
Configure Nettoplcsim, and start the Nettoplcsim server
Make your tests
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello everyone,
i try to connect NetToPlc to Tia v18 but it didn't work. I read in another forum that it work only up to tia v17, it's true?
if it's true, is a new realease work in progress?
Thank you so much
I'm using Nettoplcsim successfully together with TIA V18. Only make sure you start your simulation setup in this order:
I'll try, thank you so much!!