To use this software in my current client environement I do not have access to the "show run" command, but do have access to "show start", "show mac address-table", "sho ip arp" etc in RO access mode via SSH CLI.
Will this suffice in populating the database?
Thank you,
Matthew
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
To use this software in my current client environement I do not have
access to the "show run" command, but do have access to "show start", "show
mac address-table", "sho ip arp" etc in RO access mode via SSH CLI.
To use this software in my current client environement I do not have access to the "show run" command, but do have access to "show start", "show mac address-table", "sho ip arp" etc in RO access mode via SSH CLI.
Will this suffice in populating the database?
Thank you,
Matthew
I don't believe it is required as far as I have seen.
Sam
On Wed, Jan 17, 2018 at 2:53 AM, Matthew Earley matthewearley@users.sf.net
wrote:
Thank you for your reply