[Netadm-devel] gwc INSTALL,NONE,1.1

[&#46629;&#44844; <lin...@us...>]

Update of /cvsroot/netadm/gwc
In directory sc8-pr-cvs1.sourceforge.net:/tmp/cvs-serv24813

Added Files:
	INSTALL 
Log Message:

Initial check-in



--- NEW FILE: INSTALL ---
#
#
#   Title           : INSTALL
#   Author          : Jeho-Park <ne...@ke...>
#   Created date    : 2006. 02. 08. (wen) 02:21:58 KST
#   Description     : The manual for installation.
#
#ident  "@(#) $Header: /cvsroot/netadm/gwc/INSTALL,v 1.1 2006/02/07 18:04:03 linuxpark Exp $"


Contents
=========

1. Compilation.
2. Installation.
3. Start gwc.
4. Uninstallation.



1. Compilation.
----------------
  $make


2. Installation.
-----------------

  Before installation of gwc, you are needed to check your network environment.
  and then verify which this the case your network it is below.

  case 1 )  Have remote machine to monitoring and linux gateway to use firewall 
	    or network control system.


	    external internet +--------+ linux gateway +-------+ intranet
	                                       +
					       |
					       +---------------+ remote machine
  

             In this case, the installation process is like below

	     $su
	     #make
	     #make install
	     #Select where the target system exiest
	     
	     This target system means the remote machine to monitor
	     so just select "1. Remote" 

	     #Select whether the target system is wireless AP or IPv4 router

	     select the type of remote machine
	     If the type of your remote machine is just IPv4 supporting router,
	     select "0. IPv4 support router". 
	     or If the type of the remote machine is wireless AP but is not
	     CISCCO's, select "1. 802.11 support wireless AP but not CISCO's"

	     #Please enter IP address of target system

	     The target system means the remote machine to monitor. so
	     enter the IP address of this system.

	     #Select whether target system support SNMP query using SNMPv1.0

	     If the target system or remote machine is SNMP enabled, 
	     select "1. yes" else select "0. no"

	     note )
	     If you select "1. yes" but the target or remote machine is not
	     SNMP supporting or it can't support SNMPv1.0, you will meet
	     some problems whenever you start gwc.


  case 2 )   Both target system which also called "remote machine" and 
	     gateway are same host.

	    external internet +--------+ linux gateway +-------+ intranet

	     In this case the installation is almost same as above.
	     the only difference is the first question in installation process.
	     
	     #Select where the target system exiest

	     just select "0. This local system".


3. Start gwc.
-------------
  #gwc start
  ...
  #gwc stop

4. Uninstallation.
-------------------
   change directory to the main source directory.
  and then execute like below.

  #make uninstall