Thread: [Ndiswrapper-general] [NDISWRAPPER]: Belkin 6001DE: iwconfig: not able to change parameters
Status: Beta
Brought to you by:
pgiri
From: Matthias-Christian O. <mat...@ti...> - 2005-02-01 12:28:53
|
Hi! I have a Belkin 6001DE, I tried get it working with ndiswrapper (I tried 4 different drivers), but I wasn't able to change wireless parameters, e.g. the essid. I followed a instructions from the wiki. Compiling ndiswrapper with debug=3 didn't give an additional information. [root@iceowl ~]# lspci -v 02:01.0 Ethernet controller: Belkin: Unknown device 6001 (rev 20) Subsystem: Belkin: Unknown device 6001 Flags: bus master, medium devsel, latency 32, IRQ 12 I/O ports at 9000 [size=256] Memory at e3003000 (32-bit, non-prefetchable) [size=256] Capabilities: [50] Power Management version 2 [root@iceowl ~]# cat /proc/pci Bus 2, device 1, function 0: Ethernet controller: Belkin Wireless PCI Card - F5D6001 (rev 32). IRQ 12. Master Capable. Latency=32. Min Gnt=32.Max Lat=64. I/O at 0x9000 [0x90ff]. Non-prefetchable 32 bit memory at 0xe3003000 [0xe30030ff]. How can I get it working? Thanks Matthias-Christian Ott |
From: Jim C. <jc...@di...> - 2005-02-01 18:08:37
|
Matthias-Christian Ott wrote: > ndiswrapper with debug=3 didn't give an additional information. it would if it were in. modprobe -r ndiswrapper to remove old one, so you can then load new one. or, youre not getting it installed. if youre doing it in 2 steps make debug=3 su -c 'make install' try putting them together su -c 'make debug=3 install' this works-for-me it may be that the su'd make does a rebuild, cuz its no longer a debug=3 invoke, a different user, protections or something.. |