Ste - 2006-08-21

hi I have a Notebook Gericom in dualboot (win xp ed Ubuntu 5.1) and a card wireless realtek 8180, i am using the version 1.1 found on the ubuntu CD.
I took the driver from the page of realtek

i have installed the card and running dmesg i get this:

..............
...............

[4295143.067000] ndiswrapper version 1.1 loaded (preempt=no,smp=no)
[4295143.141000] ndiswrapper: driver net8180 (Realtek,10/07/2004,5.173.1007.2004) loaded
[4295143.141000] PCI: Enabling device 0000:02:00.0 (0000 -> 0003)
[4295143.141000] ACPI: PCI Interrupt 0000:02:00.0[A] -> Link [LNK2] -> GSI 10 (level, low) -> IRQ 10
[4295143.142000] PCI: Setting latency timer of device 0000:02:00.0 to 64
[4295143.203000] ndiswrapper: using irq 10
[4295144.804000] wlan0: ndiswrapper ethernet device 00:02:72:42:58:a3 using driver net8180, configuration file 10EC:8180.5.conf
[4295144.804000] wlan0: encryption modes supported: WEP, WPA with TKIP, WPA with AES/CCMP
[4295226.239000] ndiswrapper: device wlan0 removed
[4295226.770000] ACPI: PCI interrupt for device 0000:02:00.0 disabled
[4296199.371000] ndiswrapper version 1.1 loaded (preempt=no,smp=no)
[4296199.386000] ndiswrapper: driver net8180 (Realtek,10/07/2004,5.173.1007.2004) loaded
[4296199.397000] ACPI: PCI Interrupt 0000:02:00.0[A] -> Link [LNK2] -> GSI 10 (level, low) -> IRQ 10
[4296199.458000] ndiswrapper: using irq 10
[4296201.056000] wlan0: ndiswrapper ethernet device 00:02:72:42:58:a3 using driver net8180, configuration file 10EC:8180.5.conf
[4296201.056000] wlan0: encryption modes supported: WEP, WPA with TKIP, WPA with AES/CCMP
[4296359.030000] wlan: 0.8.6.0 (EXPERIMENTAL)
root@ubuntu:/home/ste/Desktop/wlan#


Running the "iwconfig wlan0 " i get this

wlan0 IEEE 802.11b ESSID:off/any
Mode:Auto Frequency:2.412 GHz Access Point: 00:00:00:00:00:00
Bit Rate:11 Mb/s Tx-Power:20 dBm Sensitivity=0/3
RTS thr:2432 B Fragment thr:2432 B
Encryption key:off
Power Management:off
Link Quality:100/100 Signal level:-95 dBm Noise level:-256 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0


i tried the command: iwconfig wlan0 essid default

doesnt change nothing,

what should i do?