Please contact support@sensinode.com for HW support. There you can also get access to all firmware updates through the portal as a Devkit customer.
Some quick hints:
- Check that the DIP switch settings are correct from the D210 datasheet, if not that can prevent the serial port from working.
- Also check that the FTDI driver is really working with dmesg (it assigns /dev/ttyUSB0 to your devboard).
- Zach
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I will program the N711 device, but I must use the D210 devboard to program it.
When I will use the nano_prgrammer I have this message
$ ./nano_programmer.exe -d 0 -b
Get BIOS version
Setup: Device 0.
Select D200.
No programmer found
I think that my D210 is not programmed and I'm search the firmware and I don't find it.
Where is the D210 firmware in the Nanostack's files ?
Thanks
Hi,
Please contact support@sensinode.com for HW support. There you can also get access to all firmware updates through the portal as a Devkit customer.
Some quick hints:
- Check that the DIP switch settings are correct from the D210 datasheet, if not that can prevent the serial port from working.
- Also check that the FTDI driver is really working with dmesg (it assigns /dev/ttyUSB0 to your devboard).
- Zach