The nano_usb_programmer utility is used for bit-bang programming of the CC2430 directly over the USB interface. Just the nature of the CC2430 programming interface makes that method realllly slow.
Instead program the board using nano_programmer through the D210 Devboard.
If you have HW related issues, please direct them to Sensinode or me directly as this forum is really only about the open-source SW project.
Hope that helps,
Zach
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
It tooks me one hour to program the router.
Is there a way to speed it up ?
regards,
Haluk
Haluk,
The nano_usb_programmer utility is used for bit-bang programming of the CC2430 directly over the USB interface. Just the nature of the CC2430 programming interface makes that method realllly slow.
Instead program the board using nano_programmer through the D210 Devboard.
If you have HW related issues, please direct them to Sensinode or me directly as this forum is really only about the open-source SW project.
Hope that helps,
Zach
Thanks, but I use my own test module with a FT232RL connected to a cc2430 chip.
regards,
Haluk
Try this programmer it work just fine for me.
http://www.modula.si/geek_tools_cc_flasher_en.php