i found these project on the internet and i was excited about it.
So, i bought all electronic parts and soldered on the pcb. After this, i programmed the ESP32 in the Arduino IDE.
But i have the results in the serial monitor as you can see in the attachment.
I configured the controller_config.h as i need. Also, the I2C adresses are correct.
Time by time, i worked with the ESP32 before. But this result i had not seen before.
Hi everyone,
i found these project on the internet and i was excited about it.
So, i bought all electronic parts and soldered on the pcb. After this, i programmed the ESP32 in the Arduino IDE.
But i have the results in the serial monitor as you can see in the attachment.
I configured the controller_config.h as i need. Also, the I2C adresses are correct.
Time by time, i worked with the ESP32 before. But this result i had not seen before.
Have anyone a suggestion to solve my problem ?
Thank's a lot...
Last edit: Andre Heidemann 2022-07-12
replied in thread
https://sourceforge.net/p/mysqmproesp32/discussion/general/thread/fa68b4dc6c/?limit=25