does the safety monitor when set to cloud % also monitor lux and so would say unsafe if too light?
Hi Dave
I have done some work on this. Are you in a position to test the new driver? If so, please email me - address is in the PDF
Regards Robert
cheers, emailed
addded trace log
Hi Dave massive apology, only just found this today.
No, does not. If required it can do.
But the starting point would be some rules about what should be safe/unsafe eg Rule 1: If cloud percent > 50% AND Lux < 1000 then condition = unsafe
And then apply these on a rules tab in the driver. I would need to reply on the help of others to comment and derive the required rules.
New versions will be posted in a few hours (today my time)
Log in to post a comment.
does the safety monitor when set to cloud % also monitor lux and so would say unsafe if too light?
Hi Dave
I have done some work on this. Are you in a position to test the new driver?
If so, please email me - address is in the PDF
Regards
Robert
cheers,
emailed
addded trace log
Hi Dave
massive apology, only just found this today.
No, does not. If required it can do.
But the starting point would be some rules about what should be safe/unsafe
eg
Rule 1:
If cloud percent > 50% AND Lux < 1000 then condition = unsafe
And then apply these on a rules tab in the driver. I would need to reply on the help of others to comment and derive the required rules.
Regards
Robert
New versions will be posted in a few hours (today my time)