From: <lle...@fi...> - 2002-02-21 16:24:40
|
Hi Geoff, Well there is one thing to know if you use WinCVS that is if you run any command, a DOS command window will appear (check on the task bar) and nothing is displayed inside. Just type your password then [ENTER] and the sun will shine again ;) Lo=EFc Lef=E8vre -----Message d'origine----- De : myr...@li... [mailto:myr...@li...]De la part de Mattie Envoy=E9 : jeudi 21 f=E9vrier 2002 16:19 =C0 : ALLAN LINGA Cc : myr...@li... Objet : Re: [Myrpg-development] (no subject) Actually, I am still having problems :-( I have installed WinCVS, ran the exe from SourceForge, then, at first, se= t up with SSH per the instructinos on SF install page using ":ext:gsm...@cv...:/cvsroot/myrpg" and ":ext:gsm...@cv...:/cvsroot/myrpg" as the CVS root (tried both just in case). Each time this resulted in CVS running over night, and it was still trying in the morning with no results. Then I tried the switch to "psswd" using the same settings and I get a very quick message saying CVS exited nirmally with Code 1. Obviously I have missed some critical setup ... any suggestions would be much appreciated. Geoff At 07:21 PM 2/20/2002 +0800, ALLAN LINGA wrote: >Hey Guys, > >I've finally made my CVS work =3D) In case one of you is having some >problems checking out the source codes, try this one. In >Admin>>Preferences (I'm using WinCVS) select "passwd" for authentication >and I hope it works with yours as it did with mine. > >Cheers, >Allan > > >_________________________________________________________________ >Join the world's largest e-mail service with MSN Hotmail. >http://www.hotmail.com > > >_______________________________________________ >Myrpg-development mailing list >Myr...@li... >https://lists.sourceforge.net/lists/listinfo/myrpg-development _______________________________________________ Myrpg-development mailing list Myr...@li... https://lists.sourceforge.net/lists/listinfo/myrpg-development |