I was thinking of doing the stripboard version to try this out. Looking at the stripboard jpgs versus the schematic it looks like the EN, VP and VN pins need to be issolated but are currently showing to be connected to 12V, GND and 5V.
Awaiting delivery of my parts from China and looking forward to starting on this...
Thanks.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I was thinking of doing the stripboard version to try this out. Looking at the stripboard jpgs versus the schematic it looks like the EN, VP and VN pins need to be issolated but are currently showing to be connected to 12V, GND and 5V.
Awaiting delivery of my parts from China and looking forward to starting on this...
Thanks.
Hi
there are a lot of files here, so if you could provide a link that might help me look for the needle in the haystack
NP. Although it looks like you already found them and modified the solder side view to disconnect those pins.
I'll provide a link next tme.
Thanks.