Goodnight.
I want to change my focuser pro 2 for this new version 32.
I see that everything works fine.
but I miss the end of position sensor.
Is it already integrated in the design?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi
myFP2ESP uses a new PCB and ESP chip. It offers a wide range of features over and above what is available woth myFocuserPro2.
For the ESP32 version of myFP2ESP it should be possible to add a home position switch. At present that has not been tested. The current ESP PCB does not support a home position switch,
I will upload shortly pcb v4 of esp32 that supports home position switch, Support will come in v106.
Regards
Robert
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Goodnight.
I want to change my focuser pro 2 for this new version 32.
I see that everything works fine.
but I miss the end of position sensor.
Is it already integrated in the design?
Hi
myFP2ESP uses a new PCB and ESP chip. It offers a wide range of features over and above what is available woth myFocuserPro2.
For the ESP32 version of myFP2ESP it should be possible to add a home position switch. At present that has not been tested. The current ESP PCB does not support a home position switch,
I will upload shortly pcb v4 of esp32 that supports home position switch, Support will come in v106.
Regards
Robert
Thank you very much
We will wait
The home position switch code is being tested in Firmware v106, The PCB's have already been updated for the ESP32.
regards
Robert
I would advise that you subscribe to
https://groups.io/g/myArduinoDIY
as all software is released there as a preview before eventually ending up here.
Regards