I have seen in a couple of places that the Stepper motors shipped with Tarantulas over the years have changed a little bit. This may explain why when I printed the Z-bracket upgrade V2 in this forum, the screw holes on the part did not line up with the screw holes on the motor. They were a whole 4 mm out. I checked whether the original V1 bracket had the same problem and it does. Suggest check in a CAD program before you print. I hope that this save time and filament... I printed V2 by mistake -...
https://youtu.be/Qu4HRmX57zI
https://youtu.be/hZP-9xsT098
https://youtu.be/lYmUEJrBXAo
https://youtu.be/BzqL07sXVhw