Hello,
To classify packets based on something else than destination IP (like your
case), you need to use iptables/ebtables. So, instead of:
ip route add 129.175.237.24 via 129.175.237.21 mpls $var
you would need to add a iptables rule that uses the $var. Look for examples
in the QoS experiments (e-LSP and l-LSP) for iptables syntax (the matching
there is done based on DSCP, but you can easily match ports instead).
Good luck!
Adrian
On Thu, Jun 19, 2008 at 7:14 PM, David Martínez <acu...@gm...>
wrote:
> Hello everybody!
>
> I solved my problems as far as compilation and installation of MPLS over
> linux was concerned (MPLS 1.956 over Kubuntu 7.10 (kernel 2.6.22) ). Thank
> you all for your answers.
> Right now i am trying to add different labels to the incoming traffic
> dependind on the port by which they get to the LER.
> I send data by 2 different ports (one for the video and the other one for
> the audio) to the same IP address. What i want to do is creating two
> different LSP's (audio and video).
> I don't know the linux instruction necessary that i have to use for the
> command line. Normally i used to do like this for a single IP address and
> port.
>
> var=`mpls nhlfe add key 0 instructions push gen 1000 nexthop
> eth0 ipv4 129.175.237.21| grep key |cut -c 17-26`
> ip route add 129.175.237.24 via 129.175.237.21 mpls $var
>
> Any suggestions?
>
> Thank you very much,
>
> David
>
> -------------------------------------------------------------------------
> Check out the new SourceForge.net Marketplace.
> It's the best place to buy or sell services for
> just about anything Open Source.
> http://sourceforge.net/services/buy/index.php
> _______________________________________________
> mpls-linux-general mailing list
> mpl...@li...
> https://lists.sourceforge.net/lists/listinfo/mpls-linux-general
>
>
|
