Currently the Ethernet over MPLS implementation is point-to-point because
of the issue you are refering to. I would entertain a patch that tries to
implement multipoint support.
On Tue, Oct 02, 2007 at 08:30:56AM +0800, ?????? wrote:
> Thank you, James.
> Now I can operate ebtables with mpls.
>=20
> When I operating ebtables,
> I found something strange.
>=20
> One computer has MAC address "A",
> it connects to a LER.
>=20
> In LER,
> I type commands according to the page
> http://sourceforge.net/docman/display_doc.php?docid=3D31115&group_id=3D15=
443
>=20
> After that,
> packet can transmit with MAC address "A" through network.
> But In LER,
> I can't see the MAC address "A" record in LER's bridge MAC table.
>=20
> Is this correct?
> If I want to record "A" in LER's bridge table,
> how should I make command?
>=20
> I had tried "ebtables -t nat -A PREROUTING -i br0 -j mpls --nhlfe 0x2",
> although "A" will be recorded in table,
> but packet can not forward to the mpls interface.
> Also, I had tried "ebtables -t nat -A PREROUTING --logical-in br0 -j mpls
> --nhlfe 0x2",
> but it's the same with above page.
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2005.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> _______________________________________________
> mpls-linux-general mailing list
> mpl...@li...
> https://lists.sourceforge.net/lists/listinfo/mpls-linux-general
--=20
James R. Leu
jl...@mi...
|
