Re: [mpls-linux-general] problem running mpls

[Dorin P. <dor...@gm...>]

I've solved the problem!

Thank you for your support!



On 2/23/06, James R. Leu <jl...@mi...> wrote:
>
> On Thu, Feb 23, 2006 at 08:33:32AM +0200, Dorin Pena wrote:
> > Thank you for your response!
> >
> > Yes, the module was loaded before I gave the command.
> > As I said in my previous email, some mpls commands work fine:
> >
> > dorian:~# mpls nhlfe  show
> > NHLFE entry key 0x00000003 mtu 0 propagate_ttl
> >          (0 bytes, 0 pkts)
> >
> > dorian:~# mpls nhlfe change key 0x2 instructions push gen 10000 nexthop
> eth0
> > ipv4 141.85.99.1
>
> Change 'change' to 'add' and it will work fine.
>
> PS Please make sure all mpls-linux questions and replies go to the
> mpls-linux-general mailing list.
>
> > RTNETLINK answers: No such process
> >
> > I still get this error.
> > DO you have further advice?
> >
> > Thank you for your support!
> >
> > Best regards!
> >
> > On 2/22/06, James R. Leu <jl...@mi...> wrote:
> > >
> > > Are you using the kernel RPM I created?
> > > If so did you read the release notes?
> > > From the release notes:
> > >
> > > ******* NOTE **********
> > > If you are using one of my provided kernel RPMs, you must issue a
> > > 'modprobe mpls4' before attempting any 'mpls' commands.  This is
> because
> > > MPLS is compiled as a module and must be loaded!!!!
> > > ******* NOTE **********
> > >
> > > On Wed, Feb 22, 2006 at 01:21:58PM +0200, Dorin Pena wrote:
> > > > Hello!
> > > >
> > > > I have a problem with mpls kernel 2.6.15. I have install from
> sources
> > > > downloaded from SourceForge and I also installed iproute-2.6.11.
> When I
> > > > tried to configure o simple LSP (as the example shows), I got the
> > > following
> > > > errors:
> > > >
> > > > dorian:/usr/src# mpls ilm add label gen 100 labelspace 0
> > > > RTNETLINK answers: Cannot allocate memory
> > > >
> > > > dorian:/usr/src# mpls nhlfe change key 0x2 instructions push gen
> 10000
> > > > nexthop eth0 ipv4 141.85.99.1
> > > > RTNETLINK answers: No such process
> > > >
> > > > mpls show works fine..
> > > >
> > > > Can anyone help me, please?
> > > >
> > > >
> > > > --
> > > > Dorin Pena
> > > > CCNA, CCAI
> > >
> > > --
> > > James R. Leu
> > > jl...@mi...
> > >
> > >
> > >
> >
> >
> > --
> > Dorin Pena
> > CCNA, CCAI
>
> --
> James R. Leu
> jl...@mi...
>
>
>


--
Dorin Pena
CCNA, CCAI