Re: [mpls-linux-general] MPLS tunnel on zebra

[mynor <myn...@gm...>]

Hello james

Thank you for the information
I like to ask more about that

If I want to make a tunnel using mpls
If I'm using ospf with zebra to generate my routing, what network address=
=20
that I must enter in router ospf command.
Is it I must enter network must for new tunnel IP address or network addres=
s=20
for int that connected to the router

If referring to your mail, it show that tunnel doesn't required any ip=20
address, but when I'm refering to your note in MPLS-Linux at Source Fodge=
=20
web site, it say different



On Apr 6, 2005 8:12 AM, James R. Leu <jl...@mi...> wrote:
>=20
> On Tue, Apr 05, 2005 at 11:18:47AM +0800, mynor wrote:
> > I have configure MPLS with zebra
> > I have also read the readme for quagga mpls support by JLeu
> >
> > He advise to use zebra when configuring all the label stuff
> > I like to configure MPLS tunnel on my network
> > I have found it once but I can't found it any more
> > Some body can tell me where I can configure MPLS tunnel on zebra
>=20
> zebra1(config)# create mpls-tunnel mpls0
> zebra1(config-tun)# tunnel mode mpls static gen 1000 nexthop eth0=20
> 192.168.3.1 <http://192.168.3.1>
>=20
> --
> James R. Leu
> jl...@mi...
>=20
>=20
>