RE: [mpls-linux-general] Egress Router, how?

[T. T. <t_t...@ho...>]

Hi.

I have a similar problem.
I have executed "MPLS Hierarchy" in README and succeeded to setup 200 and 
202 LSP.

                 101
    200        201       202
A------B------C------D

But, I had a problem at "On C" setting about 101 and 201. The command is

 # mplsadm2 -I gen:101:0 -i pop:peek
 In Instr: No such device or address

It didn't seem to be set properly.
When I have executed "mplsadm2 -d", the output of the above command is

mpls_set_in_label_instructions: enter
mpls_in_info_hold: enter
mpls_in_info_hold: new count 2
mpls_in_info_hold: exit
mpls_instruction_build: enter
mpls_instruction_build: exit(2)
mpls_instruction_clear: enter
mpls_instruction_clear: exit
mpls_in_info_release: enter
mpls_in_info_release: new count 1
mpls_in_info_release: exit
mpls_set_in_label_structions: exit

What should I do?
I hope any help.

>From: Jung Janos <jj...@hs...>
>To: mpl...@li...
>Subject: [mpls-linux-general] Egress Router, how?
>Date: Wed, 10 Mar 2004 16:07:18 +0100 (MET)
>
>Hi!
>
>I have a simple network...:
>
>
>
>
>
>
>PC2				PC1
>		10.130.0.0/16
>eth0 -----------switch------eth1
>0.6			0.20
>---------		---------
>|	|		|	|
>|	|		|	|
>|	|		|	|
>---------		---------
>0.6			0.20
>eth1------------switch------eth0
>		10.131.0.0/16
>
>PC2 sends on his eth0 interface MPLS packets with label=1024 (not via
>mplsadm)
>(with destination IP=10.131.0.6 (his other IP))
>PC1 receives this packets, and i would like PC1 to pop the label
>and forward it as an IP packet (check the route table, and then
>forward it to PC2-eth1)
>PC1  runns mplsadm2...
>
>How should i do that?
>
>i tried:
>PC1:
>mplsadm2 -vL eth1:0
>mplsadm2 -vAI gen:1024:0
>mplsadm2 -vI gen:1024:0 -i pop:peek
>no such device or address
>
>any idea?????????
>How should i do that?

_________________________________________________________________
メッセンジャーで総額1億円プレゼント！ http://im.msn.co.jp/home.htm