Re: [mpls-linux-general] Out label insertion error

[James R. L. <jl...@mi...>]

On Fri, Mar 12, 2004 at 12:37:53AM +0530, K Santhosh Kumar wrote:
> Hi
> 
> I am getting the following error ('Illegal seek') when
> I created an out label. But /proc/net/mpls_out shows the right entries.
> I checked the LSP. It is working properly i.e.,
> the destination machine pinging properly using the lsp I created.
> Even turning on debugging mode does not help.
> 
> I do not understand what this error stands for? Any ideas.....
> 
> 
> 
> [root@veronica root]# mplsadm2 -A -O 1 -o push:gen:18:set:eth0:ipv4:10.105.1.26
> Key: 0x00000003
> Out Segment add: Success
> Out Instr: Illegal seek

The problem is a bug with older version of mplsadm2.  You cannot create an
outsegment and set it's instructions in one command.  Do it in two commands
and it will work fine:

mplsadm2 -A -O 0
mplsadm2 -O <key output from previous command> -o push:gen:18:set:eth0:ipv4:10.105.1.26

> -----------------------
> If you don't stand for something, you'll fall for everything.
> visit me at
> www.cse.iitb.ac.in/~santhosh
> 
> 
> 
> -------------------------------------------------------
> This SF.Net email is sponsored by: IBM Linux Tutorials
> Free Linux tutorial presented by Daniel Robbins, President and CEO of
> GenToo technologies. Learn everything from fundamentals to system
> administration.http://ads.osdn.com/?ad_id=1470&alloc_id=3638&op=click
> _______________________________________________
> mpls-linux-general mailing list
> mpl...@li...
> https://lists.sourceforge.net/lists/listinfo/mpls-linux-general

-- 
James R. Leu
jl...@mi...