[mpls-linux-general] a problem about using "mpls ldp" in ldp-portable

[Guo Q. <kin...@ya...>]

Hi all
I used ldp-portable0.305+mpls_linux1.172+linux kernel2.4.19,and my topology is:
 
           11.0.2.1/24(eth1)
                |
                |
                |
                |
            11.0.2.2/24(eth1)
At each host i input these commands:
telnet localhost 1099(mplsd port)
root
en
root
config terminal
interface eth1
mpls ldp


And here are two questions:
1.I use ethereal capture the ldp packets,and found two hosts both send hello message to 224.0.0.2,but no hello message from 224.0.0.2 two 11.0.2.1 and 11.0.2.2
2.After input those commands,about 30 seconds later,two telnet process both suspended ,i couldn't input any command on telnet terminal.But ethreal shew there were packets between 11.0.2.1 and 11.0.2.2,11.0.2.1 and 224.0.0.2,11.0.2.2 and 224.0.0.2.



Thanks!

                                                                            
                                                                             Sincerly
                                                                               kings



---------------------------------
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!