RE: [mpls-linux-general] zebra ldp don't work for [static] but now OSPF....
Status: Beta
Brought to you by:
jleu
|
From: Markus H. <mh...@as...> - 2003-03-02 20:43:00
|
> -----Original Message-----
> From: James R. Leu [mailto:jl...@mi...]
> Sent: Thursday, February 20, 2003 1:37 AM
> To: Markus Hennig
> Cc: mpl...@li...
> Subject: Re: [mpls-linux-general] zebra ldp don't work for=20
> [static] but
> now OSPF....
>=20
>=20
> On Wed, Feb 19, 2003 at 10:08:33PM +0100, Markus Hennig wrote:
> > James R. Leu wrote:
> > > See comments within.
> > >=20
> > > On Wed, Feb 19, 2003 at 12:02:56AM +0100, Markus Hennig wrote:
> > > <snip>
> > >=20
> > >>ok, i changed the config for mplsd (ospfd and zebra stays!):
> > >=20
> > >=20
> > > I think you will need to change OSPF as well. Without changing =
OSPF
> > > LDP is presented with 2 equal cost OSPF routes, this is the =
fundamental
> > whats with different costs on the paths, will it work then?
> > whats the easiest way to set different costs ?
>=20
> You can have OSPF modify it for you:
>=20
....
OSPF setting with different costs was not enough....
i removed all multipath ways and now it works:
IN:13 IN:19 /
OUT:1 OUT:2 /
-LER_1----LSR_3 LER_7=20
IN:23 \ / \=20
OUT:2 \ / \ =20
LSR_6 =20
IN:19
OUT:2
=20
|----------- MPLS -------|=20
> >=20
> > > problem for the multipath case.
> > >=20
> > >=20
> > >>
> > >> .--------LSR_2 IN:74 OUT:10
> > >> / \
> > >> / LSR_5 IN:119 OUT:10
> > >> / / /
> > >> / IN:32 / /
> > >>----LER_1 OUT:5 LSR_3 LER_7 IN:53 OUT:1
> > >> IN:77 \ | \
> > >> OUT:2 \ | \
> > >> IN:98 OUT:5 LSR_6 |
> > >> / |
> > >> LSR_4-----------'
> > >> IN:17 OUT:7
> > >>
> > >> |----------- MPLS ------------|
> > >>
> > >>
>=20
|