[mpls-linux-general] No out_labels

[Paresh P. <par...@ya...>]

Hi,

I am trying to run MPLS-LDP on two machines connected
by a cross-cable.

Each machine has two cards,
other card of machine A is connected to a subnet and
that of Mchine B is connected to different subnet.
Both the addresses are /24 addresses.
So I created a dummy interface on both the m/cs with
/32 address.

After rebboting both the the machines in MPLS, I
configure zebra oboth the machines followed by
configuration of ospf.

OSPF detects neighbors etc well and detects all three
intergaces etc. This goes well.

After this I start mpls and configures it.

It just generates inlabel and no outlabel. I don't
know why is it doing so? When I repeated this with
some-change (must have assigned different ips or
interchanged eth0 to eth1.. something I don't
remember) it generated both the labels. But never
again after that. Why is it not generating outlabel?

Regards,
Paresh



__________________________________________________
Do you Yahoo!?
Faith Hill - Exclusive Performances, Videos & More
http://faith.yahoo.com