[mpls-linux-general] Network adapter(xircom) problem !

[<nit...@si...>]

Hi all,
This is what we did:
1.    Installed redhat linux 7.2 with kernel source 2.4.7-10
2.    Downloaded and patched the kernel source with mpls-linux-1.0.tar.gz
3.    Then I followed the quickstart,
        a)make menuconfig,
          turned the MPLS support on,Didnt need to touch anything else

         b)make dep.
         c)make clean.
         d)make bzlilo
4.    Now, landed up with system.map and vmlinuz in "/"  dir
There was no entry for this newly compiled kernel; so added an entry pointing to /vmlinuz and ran lilo.
5.    Then rebooted the new kernel
6.    Upon rebooting, it showed some modules were not in 
      /lib/modules/2.4.7-10custom. So created a symbolic link with that name to /lib/modules/2.4.7-10.
7.    Now, all modules got inserted except xirc2ps_cs.o. It's failing modprobe with  loads of unresolved symbols.
The other needed pcmcia modules get inserted without any problem.

There was a similar posting on the mailing list which was pointed out to config files. Now, I'm assuming that the config files installed by kernel-source-2.4.7-10 are same as those of kenel-2.4.7-10 (my older kernel)

If its not so, how can I get the older config.
Any help in this regards will be highly appreciated.
Thanx in advance. with regards. Nitinc 

-------------------------------------------------
This mail helped a tree grow. Know more at http://green.sify.com

Take the shortest route to success! 
Click here to know how http://education.sify.com