Re: [mpls-linux-general] (no subject)

[James R. L. <jl...@mi...>]

I'd just like at add one more point, if you do have an modules configured in
the kernel, make sure to do a 'make modules' and 'make modules_install'

I agree with Abhijit though, you need to figure out wht driver your ethernet
card uses and compile it into the kernel.

On Mon, Jan 14, 2002 at 11:49:08AM +0530, Abhijit Gadgil wrote:
> 
> Problem is there with the network card drivers, if you have compiled them
> as modules look for the modules path. Else u shd compile the sources for
> the network card drivers inside the kernel
> 
> (to check which network card you are using do a 'lsmod' and locate the
> installed module.) And compile its sources with the kernel sources of the
> patched-mpls sources.
> 
> -abhijit
> 
> 
> Jagdish Garg wrote :
> 
> >Hi,
> >I have downloaded the mpls-1.0 patch and applied it on Red hat 7.1 ,
> >kernel -2.4.7.
> >It got compiled successfully but when I booted from the mpls image , it
> >does not start the interface "eth0".
> >
> >While if again I try to boot it from the original image , I can see the
> >interface "etho" working.Please clarify.
> >
> >
> >Thanks and Regards
> >
> >Jagdish
> >
> >
> >_______________________________________________
> >mpls-linux-general mailing list
> >mpl...@li...
> >https://lists.sourceforge.net/lists/listinfo/mpls-linux-general
> >
> 
> -- 
> How do u delete a letter in vi and paste it after the next one?
> 
> "xp"
> 
> --
> 
> 
> _______________________________________________
> mpls-linux-general mailing list
> mpl...@li...
> https://lists.sourceforge.net/lists/listinfo/mpls-linux-general

-- 
James R. Leu