problem in up-script!

  • changizy

    changizy - 2012-07-28

    hi all
    i am new in mpd and trying to setup a pppoe server for about 7000 users in one box
    every thing is ok and all 7400 users connecting under 8 min !!
    but there is a small problem :D when i add "up-script" for shaping ,  i end with performance issue ! users now connecting very slowly !  and for 7400 users connection time is about 17 min :(
    i also tried a empty script  that runs nothing !
    so any body can help ? what do u think where i am doing wrong ?! or what should i tune ?!

  • Alexander Motin

    Alexander Motin - 2012-07-28

    Take a look on mpd's internal shaping mechanisms without using up-script. The fastest way to set up shapes is to let mpd do it in Netgraph, passing respective options from RADIUS server.

    Also make sure you've commented in /etc/devd.conf sections about interfaces up/down. Otherwise devd will run extra scripts for each interface, reducing performance.

  • changizy

    changizy - 2012-07-29

    Thanks for replay and helping ! U ARE THE BEST :D :) so i should remove up-script and use radius attribute's for shaping ? right?

  • Sami Halabi

    Sami Halabi - 2012-08-06

    can you post what fine tunings you did in the main fbsd system ??
    what version of fbsd are you using?
    mpd version?
    config file?? :)

    i would appreciate it very much to do similar configuration in here..


  • changizy

    changizy - 2012-09-02

    hi! sorry i forgot about this post ! i just copy the config file from
    and make a little change, but i have problems ! i get kernel punics! :(


Log in to post a comment.