Re: [Motion-user] (nearly) ot: v4l vs. motion on epia

[Fd <zip...@gm...>]

FWIW I've been running motion on VIA CL10000 using an osprey capture card,=
=20
100% stable, absolutely no problems . . .

Fd

On 9/2/05, Andrea Oliva <and...@ne...> wrote:
>=20
> Hi all, I'm trying to make motion work with an epia PD6000 which is a
> mini-itx board w/ fanless cpu (@600MHz).
> Don't know whether is due to the bus or the cpu but I get an error
> message on syslog:
> bttv0: timeout: drop=3D0 irq=3Dblah/blah risc=3Dblah bits: VSYNC HSYNC OF=
LOW
> RISCI
> Right after that motion dies badly (killed by sigkill).
>=20
> With a little investigation, I've found the message in syslog comes from
> bttv-driver.c (kernel), but it is considered to be simply an info, not
> even a warning.
>=20
> I tryed to put some extra logs in motion to find out the cause, without
> any form of success. :-(((((((
> Sometime I reach some code and sometime I do not.
> Since I'm running just two threads (main thread plus one for the input)
> and I put extra logs in video.c (motion), it seems to me that problems
> are outside motion itself, more likely in v4l stratum, at least with
> such hw.
>=20
> At this point: did anyone ever make motion work on such an epia?
>=20
> NOTE:
> Nearly the same setup (just different kernel) goes straightforward with
> an asus mb and P4, where I can get motion work fine.
>=20
> Bye
> A
>=20
>=20
>=20
> -------------------------------------------------------
> SF.Net email is Sponsored by the Better Software Conference & EXPO
> September 19-22, 2005 * San Francisco, CA * Development Lifecycle=20
> Practices
> Agile & Plan-Driven Development * Managing Projects & Teams * Testing & Q=
A
> Security * Process Improvement & Measurement * http://www.sqe.com/bsce5sf
> _______________________________________________
> Motion-user mailing list
> Mot...@li...
> https://lists.sourceforge.net/lists/listinfo/motion-user
> http://www.lavrsen.dk/twiki/bin/view/Motion/WebHome
>