From: <sa...@ba...> - 2001-07-18 04:40:11
|
I think the 2.52 version worked just fine. I run on a debian woody installation, and I use the 220w version of the CM11. Joel, what do you use? // Samuel > -----Ursprungligt meddelande----- > Fr=E5n: mis...@li...=20 > [mailto:mis...@li...] F=F6r=20 > Bruce Winter > Skickat: den 18 juli 2001 05:03 > Till: mis...@li... > =C4mne: RE: [misterhouse-users] Very strange X10 behaviour >=20 >=20 > I don't know what I did wrong here either! I tried your code=20 > here also, adding this line: >=20 > $AllA =3D new X10_Item 'A'; >=20 > And it worked fine. I set -debug X10 -x10_errata 4, and got=20 > this errata, along with the 'all lights is turned off speech': >=20 > CM11 data=3D90 hex=3D5a > mh CM11 data=3DZ data_d=3D90 >=20 > CM11 data=3D2 hex=3D02 > receive buffer length=3D2, mask=3D00000001, data_h=3D020160. > CM11 db: data=3DAP > Serial data: event_type=3DX, event_data=3DXAP > X10: Previous units=3D reset_flag=3D1 > X10: House code A set to P >=20 > Anyone else other than Joel and Samuel see a problem with=20 > receiving X10 data with mh 2.55? If so, what OS and what was=20 > the previous version of mh that > worked OK? If we can figure out what version it broke, we=20 > can compare > versions of Serial_Item.pm, CM11.pm to and mh/bin/mh. >=20 > Bruce >=20 >=20 > > I suddenly got a VERY strange X10 behavior on my HM linux server (a=20 > > debian server). I use some lines of code to check if any=20 > X10 commands=20 > > are sent from my remote control and when it happens I do turn=20 > > on/off/dim some lights. Just like I guess alot of you do.=20 > The code I=20 > > use looks like this > > > > if (state_now $AllA) { > > if ((state $AllA) eq "off"){ > > speak("All lights is turned off"); > > } > > } > > > > This has been working for a few months and suddenly when I=20 > upgraded to=20 > > 2.55 MH stops to react to this code! Its like the state_now=20 > $A5 never=20 > > happens. I ran the same code on my win2000 machine and it works=20 > > perfecly there. > > > > When I run MH in -debug X10 mode I get this when trying to=20 > turn on/off=20 > > all on the "A" system. > > > > CM11 data=3D3 hex=3D03 > > mh CM11 data=3D'' data_d=3D3 > > > > I guess this means that MH recievs some input but it doesnt do=20 > > anything with it!? Does anyone have any ideas, im desperate=20 > and open=20 > > to every possible idea that you may have. >=20 >=20 > ________________________________________________________ > To unsubscribe from this list, go to:=20 > http://sourceforge.net/mail/?group_id=3D1365 >=20 >=20 |