Hi Guys,
I am trying to use the Minshara for my project. I have a Philips BT 1.2 compliant development board which is connected to my RS232 interface. I tried to use some of your examples to connect this module to my TrueBlue BTM in my laptop which runs on a Widecom driver 3.0.805. I was able to find the device, gets its BT address. I was able to get the service record, but couldnt get the attributes so I had to populate it and however I was able to make up till the serviceURL. But when I try to open a StreamConnection, it just hangs up. Could you tell me any suggestions.. if you have any working code, please post it or mail me please. It is so important for me to know it saviodomnic@yahoo.com is my email.
Thanksin advance
Domnic
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi Guys,
I am trying to use the Minshara for my project. I have a Philips BT 1.2 compliant development board which is connected to my RS232 interface. I tried to use some of your examples to connect this module to my TrueBlue BTM in my laptop which runs on a Widecom driver 3.0.805. I was able to find the device, gets its BT address. I was able to get the service record, but couldnt get the attributes so I had to populate it and however I was able to make up till the serviceURL. But when I try to open a StreamConnection, it just hangs up. Could you tell me any suggestions.. if you have any working code, please post it or mail me please. It is so important for me to know it saviodomnic@yahoo.com is my email.
Thanksin advance
Domnic